
M380056-03 Rev M 53
3.
DC MODULE REMOTE PROGRAMMING
3.1
INTRODUCTION
This section covers the remote programming of the ReFlex Power™
programmable DC power supplies, High Power DC (HPDC) and Low Power DC
(LPDC). This interface enables operation of the HPDC and LPDC power supplies
from a computer via the Ethernet, allowing full remote programming control and
monitoring of the power supply.
The syntax of all SCPI commands implemented by the ReFlex Power™ system
and documented in this manual, are either SCPI confirmed in the SCPI 1999.0
Specification, Volume 2: Command Reference, or they are customized
commands not part of the SCPI definition, but conform to SCPI syntax.
3.2
FEATURES AND FUNCTIONS
F
EATURES
• 16-bit programming and 16-bit readback of voltage and current
• Programmable over/undervoltage protection with reset
• Programmable overcurrent protection
• User selectable Constant-Voltage/Constant-Current mode, with reset
• Field-upgradeable firmware via Ethernet
• Soft calibration
P
ROGRAMMABLE
F
UNCTIONS
• Output voltage and current
• Soft limits for voltage and current
• Over/Undervoltage protection
• Programmable Overcurrent trip point
• Output enable/disable
• Maskable fault interrupt
• Full calibration
Kommentare zu diesen Handbüchern