Ametek SFA Series Ethernet Programming Bedienungsanleitung PDF herunterladen (Seite 29)

SG Series Programming IEEE/RS232 Configuration and Remote Programming

M550129-03 Rev K 3-7

Table 3-2. Remote Power-on Conditions

Condition Default

Voltage

0 Volts (initial from factory power-on voltage); otherwise,

last value saved by SCPI command.

See CAL:INIT:VOLT

Current

0 Amps (initial from factory power-on current); otherwise,

last value saved by SCPI command.

See CAL:INIT:CURR

Soft Voltage Limit

Model maximum voltage *

Soft Current Limit

Model maximum current *

OVP Trip Voltage

Model maximum voltage +10% (initial from factory power-

on OVP); otherwise, last value saved by SCPI command.

See CAL:INIT:VOLT:PROT

Delay 0.5 seconds

Foldback Protection OFF (non-configurable)

Output

ON ** See CAL:MOD:POWERON

Hold OFF

Unmask NONE

Service Request

Capability

OFF

* User-programmable temporary limit (reverts to power-on defaults after power

cycle or Reset command is issued).

** User-selectable.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 158 159

Keine Kommentare

Ametek SFA Series Ethernet Programming Bedienungsanleitung Seite 29