Ametek SFA Series Ethernet Programming Bedienungsanleitung PDF herunterladen (Seite 45)

SG Series Programming Ethernet Configuration and Remote Programming

M550129-03 Rev K

5-5

Interface differs in that its banner shows “SGA” and it does not come

with the POWER or PRESETS pages.

Figure 5-4. Power Supply’s Home Page

(SGI shown here)

5.2.2

Network Setup Using Auto-IP

For this method, use a VXI-11 compliant discovery program such as National

Instrument’s NI-VISA to discover the IP address assigned to the power

supply. The power supply will assign itself an IP address in the IP address

range from 169.254.0.1 to 169.254.255.254 with a subnet mask of

255.255.0.0.

NOTE: When connecting your Sorensen unit to a network, Elgar strongly

recommends using Linksys® hubs or switches, which have undergone

extensive compatibility testing with the Ethernet interface.

1. Start with the power supply in the power-off state.

2. Connect a crossover cable from the power supply directly to your PC.

3. If the PC is already configured to obtain an IP address automatically,

skip to Step 4. Otherwise:

a. In Windows click Start, Settings, Control Panel.

b. Click open Network Connections. (For XP, if in the Category

View, click Network and Internet Connections, and then Network

Connections).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 158 159

Keine Kommentare

Ametek SFA Series Ethernet Programming Bedienungsanleitung Seite 45