Ametek SFA Series Ethernet Programming Bedienungsanleitung PDF herunterladen (Seite 68)

Ethernet Configuration and Remote Programming SG Series Programming

5-28

M550129-03 Rev K

5.5.6

PRESETS

The Presets page (only in SGI) displays stored values, which can be edited,

saved and/or recalled. The parameters for this page are:

Figure 5-18. SGI Presets Page (not in SGA)

Index: Displays memory locations named POWER ON (default power on

settings) and 1 through 9

Volts: value presently stored in memory location name

Current: value presently stored in memory location name

Over Volt: value presently stored in memory location name

Output State: displays state of the output condition presently stored in

memory location name (indicator is an open circle for OFF or a solid circle

for ON)

SAVE: saves the input values into their respective location name memory

(Must have Read/Write access)

EXECUTE: recalls the following settings into operation from its respective

memory location name (Must have Read/Write access)

If you have Read/Write access, you can save the following settings into

its respective memory location name (after inputting desired settings, click

SAVE):

• Volts: click in the Volts field and input a new value for voltage.

• Current: click in the Current field and input a new value for

current.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 158 159

Keine Kommentare

Ametek SFA Series Ethernet Programming Bedienungsanleitung Seite 68