Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung PDF herunterladen (Seite 20)

Isolated Analog Programmer Operation DLM-E Series and DCS-E Series

2.3.2 Voltage Source Programming of Output Current

SW1 Switch Settings

SW1-2 ON (1) = 0–5V

SW1-2 OFF (0)= 0–10V

2101213 1

Set up for voltage source programming of the output voltage as follows:

1. Set SW1-2, I PROG, to ON (1) for 0-5VDC programming range.

2. Set SW1-1, V PROG, to OFF (0) for 0-10VDC programming range.

3. Connect the external programming voltage source to the ISOLATED ANALOG

PROGRAMMER connector, J4, with positive to Pin-10 and negative to Pin-12.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Program the other parameters to the desired limit values.

2-8 M51A Option

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Keine Kommentare

Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung Seite 20