Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung PDF herunterladen (Seite 24)

Isolated Analog Programmer Operation DLM-E Series and DCS-E Series

2.3.6 Resistance Programming of OVP

SW1 Switch Settings

SW1-3 ON (1) = 0–5K

2361213 1

141621

Set up for resistance programming of the output voltage as follows:

1. Set SW1-3, OVP PROG, to ON (1) for 0-5VDC programming range.

2. Connect the external programming resistance, 0-5KΩ, to the ISOLATED ANALOG

PROGRAMMER connector, from Pin-3 to Pin-12.

3. Connect a jumper from Pin-3 to Pin-21 or Pin-22, (whichever one is available) to connect

the 1mA current source.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Program the other parameters to the desired limit values.

6. Connect Pin-16, OVP Default Programming Input, of the ISOLATED ANALOG

PROGRAMMER connector (J4) to Pin-6 to disable the default OVP programming

connection.

2-12 M51A Option

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung Seite 24