Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung PDF herunterladen (Seite 23)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation

2.3.5 Resistance Programming of Output Current

SW1 Switch Settings

SW1-2 ON (1) = 0–5K

2101213 1

25 22

Set up for resistance programming of the output current as follows:

1. Set SW1-2, I PROG, to ON (1) for 0-5VDC programming range.

2. Connect the external programming resistance, 0-5kΩ, to the ISOLATED ANALOG

PROGRAMMER connector, J4, from Pin-10 to Pin-12.

3. Connect a jumper from Pin-22 to Pin-10 to connect the 1mA current source.

4. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

5. Program the other parameters to the desired limit values.

M51A Option 2-11

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

Ametek DCS-E 1kW Series Programming Manual Bedienungsanleitung Seite 23